Silastic M silicone rubber is designed especially for use with urethane foams and other casting plastics.

Siliastic P-1 is suited for producing silicone print pads. It can be coloured with pigments and softened by adding fluid. Low viscosity allowing easy mixing and degassing.
Fast thick section cure at room temperature.
Very low shrinkage and good dimensional stability.
Very high tear resistance and elasticity.
Medium hardness (25 Shore A) - can be reduced by adding silicone fluid.
If required the product cure can be heat accelerated.
Can be used for high temperature casting applications.
Can be made thixotropic (non-flowable) for vertical surface replication.

Silastic T-4 is a translucent mouldmaking rubber developed for prototype design and production tooling, especially for rapid prototyping applications.